1. Material particle size and material composition of briquette briquette machine. Smaller material particle size is conducive to the close arrangement of particles. When the binder molding process is used, the optimal particle size composition should make the total size of the material smaller than the total size of the particles. The voids are also small to reduce the amount of binder, thereby reducing the production cost of briquette.
2. the water content of the material, the briquette briquetting machine production line requires that the water content of the material to be pressed does not exceed the range of the optimum water content, of course, the water content requirements of the specific material are different when it is pressed. A proper amount of water can act as a lubricant, reduce the internal friction of the molding system, and improve the mechanical strength of the briquette. If the moisture is too much, the surface layer of the particles will become thicker, which will affect the full density of the particles, but will reduce the mechanical strength of the briquette; use a hydrophobic binder for molding, and the moisture content of the material is generally controlled below 4%; For the molding of hydrophilic adhesives, the appropriate moisture content is generally 10-15%. In short, more practice is needed to control the moisture content within a good range.
3. The ratio of binder and material of briquette briquetting machine. Choosing a reasonable binder is the step of briquette briquetting. After finding the binder, it is necessary to determine the ratio of binder and material. It is generally necessary to determine a good amount of binder through experimentation.
4. The physical and chemical properties of briquette briquette machine materials, whether it is pulverized coal, briquette, or coking coal, its elasticity and plasticity have a prominent impact on briquette briquette machine. The higher the plasticity of the coal, the greater the forming characteristics of the pulverized coal. The better.
5. The molding pressure of the briquette ball press machine. The optimal molding pressure of the briquette ball press machine needs continuous experimentation. Due to the different types of coal, the moisture and particle size composition of the material, and the number of binders, the ratio requirements It is also different, so the best molding pressure needs to be continuously adjusted during production.
